Master DH 41 H Wartungshandbuch PDF herunterladen (Seite 36)

100

Manual – MOVI-PLC® advanced DH.41B Controller

Configuration with the MOVITOOLS® MotionStudio PC software

Configuration and Startup

Options for engi-

neering access

You have two options for establishing engineering access to MOVI-PLC

advanced

DH.41B via the Ethernet 2 interface (X37).

• With point-to-point connection, connect the Ethernet 2 interface (X37) of the

MOVI-PLC

advanced DH.41B directly to the Ethernet interface of the engineering

PC. On the engineering PC, choose an interface that is not used to connect the PC

to the intranet/Internet. This prevents the interface from being reconfigured.

• Integrate the MOVI-PLC

advanced DH.41B control card in a network using the Eth-

ernet 2 interface (X37). Make the necessary address settings by editing the

NetConfig.cfg configuration file in the "System" folder of the SD memory card. The

following options are available for accessing the NetConfig.cfg configuration file:

– Remove the SD memory card from the MOVI-PLC

advanced DH.41B controller

and plug it into a memory card reader/writer.

– First establish a point-to-point connection with the MOVI-PLC

advanced DH.41B

control card. Then access the NetConfig.cfg configuration file via an FTP client.

For older network interfaces, it may be necessary to use a cross cable for point-to-

point connection.

Address settings

for a point-to-

point connection

• Set the default IP address:

– Disconnect the MOVI-PLC

advanced DH.41B control card from the voltage

supply.

– Change DIP switch S1 to the top position.

– Apply voltage to the MOVI-PLC

advanced DH.41B control card. The IP address

192.168.10.5 and the net mask 255.255.255.0 is automatically assigned to the

Ethernet 2 interface of the MOVI-PLC

advanced DH.41B control card.

• Set a different address:

You can set other addresses by editing the <Ethernet2...> section manually in the

NetConfig.cfg configuration file in the "System" folder of the SD memory card.

Example:

<Netmask>255.255.255.0>/Netmask>

<Hostname>MOVI-PLC_Eth2>/Hostname>

</Ethernet2>

Change DIP switch S1 to the bottom position. Doing so makes sure that the address-

es will take effect when the MOVI-PLC

advanced DH.41B is restarted.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare

Master DH 41 H Wartungshandbuch Seite 36

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Luftentfeuchter Master DH 41 H